All CNC machinists know that coolant is required to keep machining equipment from overheating, and this coolant quickly becomes contaminated with solids, oil or sludge. You accept it as a fact of life, but the work you’re doing is a particularly dirty job, and this dirt and waste damages machinery and slows down production.Not only do you spend time disposing of the used coolant and waste, but you spend a lot of money doing so. Disposal is expensive because the waste must be disposed of properly since it is environmentally hazardous and then you have to buy replacement fluid as well.All of these issues get in the way of you doing your job in the most efficient and cost effective way. But, there is a way to reduce waste, the money it costs and the cost of disposal.Work Without WasteA coolant filtration system removes the dirt, oil, and sludge from your coolant, allowing you to recycle it several times before you must dispose of it. This reduces the overall amount of waste for disposal, saving you on disposal costs, and helping you do your part for the environment. You can save as much as 90% on disposal costs by filtering and reusing your coolant.A coolant filtration system also saves big money on the costs of buying coolant. Because the coolant is now reusable, you’ll buy far less than before. In fact, it’s estimated that you’ll save between 45 and 80% on the amount spent on coolant each year. It’s easy to see how this system pays for itself in savings.Don’t let waste get in your way. Save time and money by using a coolant filtration system for the fluids you use for metalworking. It’s smart business, and it keeps all that waste well out of your way, allowing you to focus on the primary intent of your business.