|
EdjeTech’s oil water separator system (T.O.S.S.
T1) is an economical solution to
eliminate tramp oil problems. The
T.O.S.S. T1 is priced so that one can be
put on every machine tool sump in the
shop.
We designed T.O.S.S. T1 to extend the
life of water-soluble oils,
semi-synthetic, and synthetic based
coolants. It does this by removing free
floating, dispersed and loosely
emulsified tramp oils from machine
reservoirs. Screw machines shops will
find the T.O.S.S. T1 beneficial on their
coolant sumps because it greatly extends
the life of the parts wash water bath.
Oil Water Separator System (T.O.S.S. T1)
Applications
EdjeTech's T.O.S.S. T1s are found in
metalworking shops on the following
types of machines:
-
Grinding
-
Turning
-
General Machining Operations
-
Parts Washers
-
Chemical Waste Treatment Systems
Oil Water Separator System (T.O.S.S. T1)
Operation
-
The air pump pulls contaminated
coolant from the machine reservoir
through the small 2”diameter
floating skimmer
-
The fluid is then discharged into
the bag filter where suspended
solids are removed
-
The fluid flows through the bag and
into the coalescing chamber where
tramp oils and mechanically
dispersed oils are split from
coolant
-
The clean fluid flows out of the
unit through the clean discharge
hose that has been placed in the
coolant reservoir.
The T.O.S.S. T1 can be run while the
machine tool is in operation and
requires no attention other than bag
filter changes.
The tramp oil separator system is
completely enclosed to make a compact
and efficient system.
-
Removes virtually all tramp oil and
mechanically dispersed oils
-
Removes suspended solids
-
Strong 10 gauge steel construction
-
2 GPM flow rate
-
Runs while machine tool is in
operation
-
Model #1052 handles parts wash
waters up to 200 deg. F.
-
More efficient than decantation,
belt, wheel and rope skimmers
-
Shipped ready-to-use when it arrives
at your facility
|
