Manual Clean

High Efficiency, Low Speed High Efficiency, Low Speed Centrifuge

The Line Backer tm Centrifuge is a low speed (700 rpm) triple-bowl design. Due to its advanced engineering it achieves the same performance as a high-speed centrifuge.

The Line Backer tm Centrifuge comes in Double-bowl or Triple-bowl design. The Double-bowl centrifuge has a maximum flow rate of 15 GPM and the Triple-Bowl has a maximum flow rate of 30 GPM. Your application requires more than 30 GPM, No problem; by combining centrifuges together we can meet your application requirements affordably.

The Double-Bowl or Triple-Bowl centrifuge can be purchased as a single unit or combined with a solids pickup system, clean fluid holding tank, and clean fluid supply pump to work off of an existing sump or replace the sump.

The CMS-15 is a 15 GPM rated centrifuge with a base. This unit is used on the outside of a tank and requires a supply pump which can be provided by EdjeTech or the client.

The contaminated fluid is discharged from the supply pump into the centrifuge where the solids are removed by the spinning bowls. The solids are pushed against the side of the bowls and the fluid flows up and over the bowls and drains out the side of the CMS-15.

Benefits

  • Extended coolant life
  • Improved surface finish
  • Longer tool life
  • Less machine down time
  • Increased production
  • One person servicing without tools

Applications

  • Centerless grinding
  • Form and thread grinding
  • Thread rolling
  • Glass grinding
  • Honing
  • Quench oils
  • Vibratory finishing

Features

  • Trouble-free operation
  • Low speed operation reduces vibration and wear
  • No replacement cartridges or roll media
  • Up to 3 times the solids capacity compared to single bowl centrifuges
  • Bowl cleaning unnecessary between startups
  • Reduced service requirements